For me, it’s CAD software. FreeCAD is trash (sorry, lovers). Fusion360 is honestly the best out there for free. The “almost there” app is Shapr3D, but fuck $40/m.
And yes I’ve tried all the others not listed here.
For me, it’s CAD software. FreeCAD is trash (sorry, lovers). Fusion360 is honestly the best out there for free. The “almost there” app is Shapr3D, but fuck $40/m.
And yes I’ve tried all the others not listed here.
What issues have you had? What features do you wish it had?
I wish the UI/UX wasn’t made by people who still live in 1995, as a major start.
Not OP, but FreeCAD auto-constraints in sketches are all over the place, and figuring out which constraint is a problem and selecting the right element in the UI is terrible.
Maybe I’m misunderstanding you, but FreeCAD tells you when a constraint is redundant, and clicking on it highlights the respective constraint in the sketch:
References
The redundant constraint detection works pretty well and FreeCAD usually remove them.
The main issue for me is that certain auto-constraints will not work as they advertise on your cursor.
The biggest culprit for me is the coincident constraint.
Let’s say that you have two lines in a 90 degree corner. If you add a line in the middle of any of the two lines, the cursor shows you that it will add a coincident constraint. But when you create your line, the coincident constraint isn’t applied.
And the other thing for me is that navigating which part of a line (and which line) is selected is not intuitive and correcting or adding constraints to fully constraint the drawing is a wild goose chase.
I’m not sure I understand what you mean by this. Could you elaborate?
What you’re describing sounds more like a bug to me. At any rate, I wasn’t able to confirm the behavior you described (maybe I’m misunderstanding you?):
I was able to get both a symmetric constraint (green arrow), and a coincident constraint (red arrow) on the two 90 degree lines.
References